Capacity 1.5 to 5 Tons Models: HC1891VAR HC2491VAR HC3091VAR HC3691VAR Installation & Operation Manual Central
1.Tubing should be cut square. Make sure it is round and free of burrs at the connecting ends. Clean the tubing to prevent contamination from enter
1.Fully open both shutoff valves.2.Connect service gage manifold to the valve service ports, being sure to evacuate lines.3.Startup the system (Ref
The condensing unit rating plate and the tables of "Physical and Electrical Specifications / OutdoorUnits" (Table 1 and 2) provide pertinent
8.OPERATIONMost single phase units are operated without start relay or start capacitor. Such systems shouldbe off for a minimum of 5 minutes before re
Run or start capacitor defective Replace Loose connection
5PUELECTRIC HEATER KITRDBLAir Conditioner Wiring Diagram1) Confirm system selection. Optional components may be field or factory installed.2) If LPS
Made in P.R.C.
! WARNINGThese instructions are intended as an aid to qualified, licensed service personnel for proper installation,adjustment and operation of this u
TABLE OF CONTENT1.Introduction ---------------------------------------------------------------------------------------2.Nomenclature for Model Number
3.SPECIFICATIONThe dimensions for the condensing unit are illustrated in Figure 1. Physical and electricalspecifications are provided in Table 1 for 9
Model:HC18-6091VARTable 1:2HC6091VAR HC4891VAR HC4291VAR HC3691VAR HC3091VAR HC2491VAR HC1891VAR56000 46000 40000 34000 28000 23500 1800036 29
4.UNIT INSPECTIONThis product has been inspected at the factory and released to the transportation agency withoutknown damage. Inspect exterior of car
Provide a level concrete slab. To prevent transmission of noise or vibration, slab should not be connectedto building structure. Some sort of sound-ab
OUTDOOR UNITLIQUID LINEPITCH SUCTION LINE TOWARD OUTDOORUNIT 1/2" FRO EVERY 10' OF LINEINDOOR UNIT ABOVE ORLEVEL TO OUTDOOR UNITINDOOR UNITO
The factory charge is sufficient for 25 feet of standard liquid line. For longer or shorter liquid linelengths, adjust the charge as follows:1/4"
Comentarios a estos manuales